Rear View Camera Kit for Ford Mondeo (SYNC 3)

An integrated high-quality rear view camera kit, designed to work with your factory SYNC 3 system. A discreet wedge camera that will give you fixed guidelines and with its unique Sony CMOS lens the resulting image on the screen is fantastic.

Wedge Camera

The high quality Sony lens with CMOS chip set, is drilled in just above the number plate which gives a discrete look. The CMOS chip set will give you a clear and sharp picture in low light conditions, also the camera will work perfectly well in rainy conditions.  

Camera Specifications

• IP Rate – IP67 (waterproof/ dust resistant)
• 170 Degree viewing angle
• Illumination down to 0.1 lux
• Displays parking grid lines
• Resolution 520 (TV line)
• NTSC format
• Dimensions 34mm x 30mm

This kit has been specially designed to work with a Ford Mondeo and has been perfected to link the camera image with the factory fitted SYNC 3 screen.

Camera activator is supplied with this kit. NOTE: Once used on one car; the activator will not work with other cars, it is important to keep this activator safe as it can be used again on only on the same car if needed.

Benefits of having a reversing rear view camera kit

• Guidelines can be really helpful so the driver knows exactly the width of the vehicle to park.
• Clearly show the ground behind the car, of which may not normally be visible from the driver’s view (blind spots)
• Greater vehicle safety management
• Makes driving much more convenient

*Installation is optional via the dropdown

Refer to the compatibility section to check your vehicle variant is supported.

NOTE: A reversing camera kit is ONLY a Parking Aid and should not be relied on solely. Please check your surroundings at all times before carrying out a Reversing Manoeuvre. Where Guide lines are included, the guide lines are generic to all vehicles and hence fixed width and not adjustable to the width of the vehicle.