Audi A4 (B7) (2005-2008) Single/Double DIN car stereo fitting kit with CANbus/SWC (FULLY AMPLIFIED)

Complete stereo upgrade fitting kit to install a Single/Double DIN aftermarket car stereo in Audi A4 (B7) (2005-2008) car models with Steering wheel controls and fully amplified sound systems.

This head unit fitting kit includes:

• Antenna adapter cable (21-139K)
• Audi Quadlock Steering wheel control interface with amplifier turn on (49-AUD-03)
• Universal patch lead for steering control interface (49-025)
• Audi A4 Single/Double DIN car audio radio fascia adapter (50-314)
• Double din fitting cage (51-012)

Double Fakra to DIN aerial adapter (Phantom Power) with Bullet connector (21-139K)

Double Fakra to DIN antenna adapter cable with 12v phantom power from a male bullet connection. This antenna adapter cable adapts from the original Double Fakra connector in the vehicle to a standard aftermarket radio DIN antenna connection for the fitting of a stereo upgrade.

Audi Quadlock Steering wheel control interface with amplifier turn on (49-AUD-03)

Car audio and steering wheel control interface for Audi cars that have quadlock connectors behind the radio and have fully amplified BOSE audio systems.This CANbus steering wheel control interface will allow you to retain the use of the steering wheel audio controls. Gives volume, seek, source, and telephone commands to an after market radio.

The quadlock adapter has 4x phono pre-out connectors to integrate with the original amplifier in the car.

The CANbus interface will generate an ignition power supply to the new radio, via the red wire. it will also give out an illumination signal, (orange) speed pulse signal (pink), reverse gear positive output (Purple), Handbrake negative (Green) and Mute out (Yellow/Black)

PLEASE NOTE: This interface provides a CAN signal to switch on the amplifier

Universal patch lead for steering control interface (49-025)

Universal patch lead to be used with In car Tec 49 series steering wheel control interfaces. Use for Alpine, Clarion, JVC, Kenwood, Pioneer and Sony head units.

Audi A4 Single/Double DIN car audio radio fascia adapter (50-314)

Audi A4 car radio fascia adapter panel to allow the fitting of an aftermarket Single or Double din car stereo upgrade. The fascia adaptor allows the fitting of an aftermarket radio into the dashboard by matching the shape, style and colour of the original radio. Use the supplied pocket with the fascia adapter to fit a single din radio, or remove the pocket and use the fascia trim only with a 103mm fitting cage to fit a double din after-market head unit. Most aftermarket radios are supplied with a 113mm high cage, because of this an additional 103mm fitting cage is included with this kit.

Double din fitting cage (51-012)

This kit is designed to replace the metal cage kit that is usually supplied with your new aftermarket double din head-unit or navigation system. It is used along with fascias that have 103mm high hole sizes. Complete with fixings to attach to the new car radio body.

This product has been developed through carefully documented data and research. The manufacturer & supplier cannot be held responsible for discrepancies/inconsistencies that may occur due to vehicle manufacturing changes or options, or damage that may occur in the vehicle during the installation of components. All application data is subject to change.

Refer to the compatibility section to check your vehicle variant is supported.