SAAB 9-3 (2006-2013) Double DIN car stereo upgrade fitting kit (DELPHI/ FUJITSU)

Complete stereo upgrade kit to install a Double DIN aftermarket car stereo and retain the use of the steering wheel controls in a SAAB 9-3 (2006-2013) vehicle, originally fitted with either the Delphi Grundig head unit or the Fujitsu Ten head unit.

This complete stereo upgrade fitting Kit includes:

• Amplifier retention interface (20-273-SAAB)
• FM antenna adapter (21-108)
• Steering control interface (29-UC-050-SAAB)
• UNICAN patch lead set (29-UCCAB-SET) 
• SAAB 9-3 Mk2 Facelift Single/Double DIN fascia (50-311)
• Double DIN metal cage kit (51-012)

Amplifier retention interface (20-273-SAAB)

This interface converts the high level audio output of a new head unit to a low level pre amplified signal which will work with an amplifier. 4 adjustable channels for optimum audio quality, it has a built in ground loop isolator and filters to get the best sound from the amplifier.

FM antenna adapter (21-108)

Antenna cable adapter for Saab cars after 2007 that had Delphi Grundig navigation radios. This cable converts the cars existing special aerial plug to an after market DIN type used by most car radio manufacturers.

Steering control interface (29-UC-050-SAAB)

Saab Car Audio Steering wheel interface allowing use of original buttons with a new aftermarket head-unit. Use with Saab cars with GM LAN bus connectors behind the radio. Does not include Telephone answer and reject features. This model is universal and can be used with Alpine, Blaupunkt, Clarion, Pioneer, JVC, Kenwood, Sony or Zenec Head-units. It is supplied complete with instructions on how to code the head-unit to the interface.

UNICAN patch lead set (29-UCCAB-SET) 

Patch cable set to connect a UNICAN interface between an after market head unit and the steering wheel controls. Can be used with Alpine, Kenwood, JVC (single wire), Pioneer, Sony and Chinese/Resistive learning head units with either two wires or a 3.5mm jack.

SAAB 9-3 Mk2 Facelift Single/Double DIN fascia (50-311)

Car radio fascia adaptor panel to allow the fitting of an aftermarket single or double din car radio upgrade. The fascia adaptor allows the fitting of an aftermarket radio into the dashboard by matching the shape, style and colour of the original radio. Use the supplied pocket with the fascia adapter to fit a single din radio, or remove the pocket and use the fascia trim only with a 103mm fitting cage to fit a double din after-market head unit. Most aftermarket radios are supplied with a 113mm high cage, because of this the 103mm fitting cage with this kit is required.

Double DIN metal cage kit (51-012)

This kit is designed to replace the metal cage kit that is usually supplied with your new aftermarket double din head-unit or navigation system. It is used along with fascias that have 103mm high hole sizes. This cage kit comes complete with fixings to attach to the new car radio body.

PLEASE NOTE:
This kit is for Saab 9-3 mk2 facelift models from 2006 onwards, fitted with either the Delphi Grundig head unit or the Fujitsu Ten head unit.
This interface comes with a universal patch lead which can be used with Alpine, Kenwood, JVC, Pioneer, Sony and Chinese/ Resistive learning Head-units.

This product has been developed through carefully documented data and research. The manufacturer & supplier cannot be held responsible for discrepancies/inconsistencies that may occur due to vehicle manufacturing changes or options, or damage that may occur in the vehicle during the installation of components. All application data is subject to change.

Refer to the compatibility section to check your vehicle variant is supported.