Audi A3 (8P) (2006-2013) Single/Double DIN car stereo fitting kit with SWC (FULLY AMPLIFIED SYSTEMS)

Complete stereo upgrade fitting kit to install an aftermarket Single or Double DIN car stereo and retain the original steering wheel controls in Audi A3 8P facelift (2006-2013) cars with fully amplified sound systems.

This head unit fitting kit includes:

• Antenna adapter cable (21-139K)
• Audi Quadlock Steering wheel control interface with amplifier turn on (49-AUD-03)
• Universal patch lead for steering control interface (49-025)
• Fascia adapter panel (50-271)

Double Fakra to DIN aerial adapter (Phantom Power) with Bullet connector (21-139K)

Double Fakra to DIN antenna adapter cable with 12v phantom power from a male bullet connection. This antenna adapter cable adapts from the original Double Fakra connector in the vehicle to a standard aftermarket radio DIN antenna connection for the fitting of a stereo upgrade.

Audi Quad-lock Steering wheel control interface with amplifier turn on (49-AUD-03)

Car audio and steering wheel control interface for Audi cars that have quad-lock connectors behind the radio and have fully amplified BOSE audio systems.This CANbus steering wheel control interface will allow you to retain the use of the steering wheel audio controls. Gives volume, seek, source, and telephone commands to an after market radio. The quadlock adapter has 4x phono pre-out connectors to integrate with the original amplifier in the car.

The CANbus interface will generate an ignition power supply to the new radio, via the red wire. it will also give out an illumination signal, (orange) speed pulse signal (pink), reverse gear positive output (Purple), Handbrake negative (Green) and Mute out (Yellow/Black)

Universal patch lead for steering control interface (49-025)

Universal patch lead to be used with In car Tec 49 series steering wheel control interfaces. Use for Alpine, Clarion, JVC, Kenwood, Pioneer and Sony head units.

Audi A3 (2003-2013) Single/Double DIN car audio fascia adapter with removable pocket (50-271)

Replacement car audio fascia to enable you to change the original radio in the car to a Single and Double DIN aftermarket version. A removable pocket is included for Single DIN installation.

COLOUR: MATT BLACK

PLEASE NOTE:

• This interface provides a CAN signal to switch on the amplifier
• The fascia will require a standard 113mm high metal cage as used by most aftermarket head-unit manufacturers. This cage is normally provided with the unit. If not, you will need our cage item number 51-013.
• A flush mount PRO-fit style fascia is also available, please see 50-271-PRO

This product has been developed through carefully documented data and research. The manufacturer & supplier cannot be held responsible for discrepancies/inconsistencies that may occur due to vehicle manufacturing changes or options, or damage that may occur in the vehicle during the installation of components. All application data is subject to change.

Refer to the compatibility section to check your vehicle variant is supported.