Dashmount 711075F Upper Console Mounting Bracket Ford Fusion 2006 > Vent
- Brand: Dashmount
- Product Code: 711075F
- Easy Returns
The (711075F) dashmountTM bracket will enable you to fit your car phone cradle, phone holder or iPod cradle without having to make screw holes in the dashboard fascia of your vehicle. All DashmountTM mounting brackets are TUV safety approved, beware of cheaper imitations!
Check the compatibility section if supported with your car make and model
Made from top quality steel that has a special black powder coating to ensure a neat finish. These brackets have pre drilled holes and slots to suit most of the common hands free car kit cradles and phone holders on the market. The brackets utilise either tape and grippers or the screws that are already in your vehicle but are hidden from sight. Fitting instructions are included with each bracket purchased - some trim removal may be required.
All DashmountTM brackets should be installed by a suitably qualified person. Neither Car Communications or DashmountTMaccepts any responsibility for any damage caused to the vehicle whilst attempting to install the bracket.
Easy-Fit robust and stylish DashmountTM mounting bracket, giving a damage free installation of mobile phone cradles, iPod Car Kit cradles and other portable devices offering easy access while giving an integrated look with your dashboard and interior. DashmountTM brackets are vehicle specific resulting in optimum design and simple installation for your particular car make and model.
- Damage free installation of mobile phone cradle, ipod cradles or other portable devices
- Easy-Fit robust and stylish Dashmount mounting bracket
- TUV safety approved
If you are unsure about the suitability of this product with your car please submit an enquiry form by clicking ask us about this item found at the top of this page.
|Ford Compatibility Chart|
1. May require trim removal tools. Check installation section for further details
If you are unsure about the compatibility of this product with your car please submit an enquiry form by clicking ask us about this item found at the top of this page.
You may require trim removing tools for installing this product.
Step 1. Remove the Ford radio with the Ford removal keys: disconnect the aerial and harness and set aside.
Step 2. Remove the Torx 20 screw in the centre of the rear of the housing beneath the radio.
Step 3. Remove the two Phillips screw in either side of the radio recess.
Step 4. Unclip the vented blanking plate and the two switches on the top of the fascia panel.
Step 5. Remove the Phillips screws behind each.
Step 6. Unclip the upper fascia panel.
Step 7. Locate the bracket with e Phillips screw behind the heated rear window switch. You can fit the bracket on the left hand screw behind the blanking plate if desired.
Step 8. Refit all parts.
If you require help with installation please submit our enquiry form by clicking ask us about this item found at the top of this page after you have purchased the item. We will more than happily provide free telephone or email support.